No products
High-quality replacement gudgeon pin circlips from Malossi for 10mm and...
The HAT weights are very durable and self lubricating. Available in a...
Pro Taper is well known for manufacturing high-quality grips and...
Budget weights by Motoforce, choice of weights. Available in a range of...
Replacement reed valve gasket for all Minarelli Horizontal engines.
The thermal grade of the spark-plug is of prime importance with tuning...
We can offer high-quality exhaust gaskets for all common original, sport...
The Polini FOR RACE crankshafts are developed to increase the...
The Polini FOR RACE crankshafts are developed to increase the...
These HI-SPEED variators are Polini's...
Reference: S6-5819506
Brand: Stage6
With their new SportPRO variator kit, Stage6 again introduce a state-of-the-art tuning part into their product range. The variator comes adjusted for use with a 50cc cylinder and a Stage6 ProReplica exhaust system. It has been developed and optimised for use with Stage6 SportPro/ Streetrace or similar 70cc sport cylinders though. The back of the variator...
Reference: 33225
Brand: Scootertuning.ca
Universal choke lever with cable.
Reference: S6-3219066/VT
Brand: Stage6
This vulcanised two-reed block completes your Stage6 setup and is ideal to assist cylinder charges with 19mm carbs and more. The layout has been adapted from the reed valve of the well-known intake system. Included in the package are the reed valve made of fuel-resistant Viton as well as 0.35mm Stage6 carbon reeds, 0.4mm fibreglass reeds and three...
Reference: 5DA-E5461-10-00
Brand: Yamaha
Replacement OEM Yamaha parts.
Reference: BT13984
Brand: Scootertuning.ca
Throttle cable with a 75" total length, 45 degree angle mount. Can be used on both ruckus or gy6 carb. Type II throttle cable is for the models, where the cable is screwed to the handlebar mount. If in doubt, compare the images with your own throttle cable. The length of the supplied component is approximately 190cm.
Reference: S6-4217500
Brand: Stage6
Stage6 CDI will get rid of any inconvenience caused by the restriction. Most models come factory-fitted with a rev limiter, usually activated at 8,000rpm.
Reference: P36619
Brand: Replay
Reference: 19739
Brand: Scootertuning.ca
Replacement front headlight bulb for two-wheeled vehicles as well as quads/ATV’s with BA20d base. 12V bulb with 35/35W. Please check your item against the image for added assurance.
Reference: S6-5916607
Brand: Stage6
The Stage6 Pro drive belt is an inexpensive high quality drive belt produced by Bando in Japan. It has optimised grip characteristics that guarantee excellent power transmission.
Reference: YAS002
Brand: Yasuni
Individual Yasuni stickers like the ones seen on their exhaust systems.
Reference: P139
Brand: Replay
Reference: S6-SSP630ET003
Brand: Stage6
We offer here adaptator for use M8 Stage6 mirror on scooter with M10 mirror thread.
Reference: 527643
Brand: Malossi
High Quality race clutch from Malossi. You can adjust the rpm at which the clutch engages by increasing the spring preload. You need a bit of dexterity for this, though.
Reference: 203.0157
Brand: Polini
Reference: MF96.90037
Brand: Motoforce
Banjo bolt for master cylinder units and brake calipers with M10x1.25 threads. NOTE: Don’t forget to check the thread size!
Reference: A365996
Brand: Tun'R
Reference: S6-SSP140/
Brand: Stage6
Oil Filler Cap Stage6 Minarelli (e.g. Yamaha Aerox) - stylish colorful anodized oil plug for optimal sealing of the crankcase. Well-sealing oil filler screws are crucial for the operability of the gearbox. The oil plug closes the filler opening of the case, a high-quality O-ring ensures perfect sealing. The oil plugs are made of a high quality aluminium...
Reference: SCTFR039
Brand: Scootertuning.ca
We can offer here Quality fairing for Yamaha Bws/Zuma 2002-2011.
Reference: 341.0027
Brand: Polini
The Polini Big Evolution grips are made from two different rubber compounds. The inner part of the grip that contacts the handlebar is made from a harder rubber compound and thus offers increased stability. The outer part of the grip that contacts the hand / glove is made from a softer rubber compound to give the best possible grip in all conditions. Set...
Reference: 2513056B
Brand: Malossi
Replacement parts for Malossi MHR Overrange variator.
Reference: TH03ADIO50-01
Brand: Scootertuning.ca
Reference: SCT-GA011
Brand: Scootertuning.ca
Remplacement gearbox cover gasket for PGO and Genuine Scooter.
Reference: P24272
Brand: Replay
Reference: 250.026
Brand: Polini
Polini's new clutch bell now also features a shrunk-on finned ring the way it has already been employed for a while by Malossi. To further enhance the ventilation of the clutch, the sidewalls are equipped with bigger cut-outs. Very recommendable for highly tuned engines that are often accelerated and decelerated, e.g. in circuit racing or in scooters in...
Reference: 527880
Brand: Malossi
Very durable high quality clutch with three shoes and large linings. It is also equipped with several lock-in positions that allow for adjusting spring preload, which takes a bit of skill and strength, though. A great choice for high end engines.
Reference: 33226
Brand: Scootertuning.ca
Universal choke lever with cable.
Reference: TRS-BBW523/
Brand: TRS
FINALLY! A Battery Box Washer Kit that fits with the right size bolts and washers. Add that last finishing touch to your project with these all new TRS battery box dress up kit! Each kit includes 4 x 5mm washers, 3 x6mm washers and stainless steel bolts to replace the factory hardware on the Battery Box. Offered in anodized black, red, and raw, these...
Reference: 5514396
Brand: Malossi
Malossi is proud to offer its new Digitronic ECU with variable ignition timing! Compared to the original ECU, Malossi has completely modified the ignition timing performance maps and increased the rev limit by 1000 RPMs. The new Digitronic controls the ignition timing, SAS valve, and PTC heater performance maps. The ignition timing is controlled by...
Reference: SCTFR011
Brand: Scootertuning.ca
We can offer here Quality fairing for Yamaha Bws/Zuma 2002-2011.
Reference: MVT-PX20
Brand: MVT
High Performance Ignition coil from MVT in spain. Can be used as replacemetn for the Premium / Digital direct igntion but this is also a very good ignition coil for all others performances ignitions.
Reference: 215.0430
Brand: Polini
Polini also offer a two-part intake manifold, consisting of a base plate and a flexible, angled rubber part, which will be squeezed between base plate and engine intake. The manifolds come with different passage and union diameters and are available for all common Dellorto, PWK, Mikuni and Keihin carburettors.
Reference: S6-7416607
Brand: Stage6
The successor of the popular Stage6 70cc Racing cylinder is called Stage6 Racing MKII 70cc. It has been completely revised and has 1hp more out of the box. Re-designed aluminium cylinder with high-strength hardchrome coating. The former flat piston has been abandoned in favour of an R/T replica with 0.8mm ring and domed crown. The thermal stability has...
Reference: STR-687.12/BT
Brand: Str8
The STR8 LED Mini II indicators are the new, even smaller version of the LED Mini indicators. Despite their small size, the 6 LEDs provide as bright light as their predecessors. The indicators come with an E-mark so they can be legally used on the street.Attention: On some scooters, LED indicators don't work correctly; in that case you will have to...
Reference: 33240
Brand: Tun'R
Tun'r Mirror adaptor M8 to M10, M10 to M8 with standard or reverse thread.
Reference: 466739
Brand: Tun'R
Tunr' offer here Quality adjustable angle airfilter with red foam at bargain price! Your carburetor will get more air, dirt and other impurities will be filtered out and your engine will have more racing sound.
Reference: STR-667.10
Brand: Str8
Please note that you will need 1 resistor per side.