No products
High-quality replacement gudgeon pin circlips from Malossi for 10mm and...
The HAT weights are very durable and self lubricating. Available in a...
Pro Taper is well known for manufacturing high-quality grips and...
Budget weights by Motoforce, choice of weights. Available in a range of...
Replacement reed valve gasket for all Minarelli Horizontal engines.
The thermal grade of the spark-plug is of prime importance with tuning...
We can offer high-quality exhaust gaskets for all common original, sport...
The Polini FOR RACE crankshafts are developed to increase the...
The Polini FOR RACE crankshafts are developed to increase the...
This is the ignition of the French...
Reference: IP34993
Brand: Scootertuning.ca
Load resistor with 25w and 10 ohm for LED indicators. Required for any LED upgrade. The resistor evens out the missing current form the standard light and gaurantees the required flashing frequency. Note: one per side required.
Reference: BZA30418
Brand: Scootertuning.ca
Vacuum controlled petrol cock / fuel tap for MBK Booster and Yamaha BWs scooters. Faulty fuel taps often lead to starting and running problems due to lack of, or too much fuel. Always best to replace the whole unit to solve the problem.
Reference: 343.0019
Brand: Polini
For those models, where it is difficult to get to the choke lever of the PWK carburettors from Motoroforce, this adaptor allows for converting to choke cable. We recommend using a fitting choke cable from Stage6 or Polini.
Reference: 0812036
Brand: Malossi
0
Reference: S6-802002/XL
Brand: Stage6
High quality silver small end bearing from Stage6. The best bearings available on the market! The original item should be replaced when using a new crankshaft or tuning cylinder. Attention: Cannot be used with Malossi and Stage6 cranks, only original crankshafts!
Reference: 298740
Brand: Malossi
Clutch springs for sport & racing clutches. Harder clutch springs result in clutch engagement at higer revs (and therefore higher power development) and gives much better acceleration from standstill.
Reference: 668102B
Brand: Malossi
This new small end bearing has been designed specifically for the MHR Team crankshaft.
Reference: NK200.07
Brand: Naraku
Universal quick-action throttle for all scooters, quads ATVs etc. with 22mm diameter handle bars. Generally the throttle cable does not need to be adapted in any way, meaning it’s easier to fit a tuned carb or swap to a twist grip on a quad. High quality set with great design. Ideal for changing over from thumb to twist grip throttles on quads.
Reference: MF10.13001
Brand: Motoforce
High-quality replacement gasket that will be fitted below the alternator.
Reference: SCT-R20184
Brand: Scootertuning.ca
RMS speedo cable in OEM quality, availabe at a good price.
Reference: 176.1205
Brand: Polini
Polini brake shoes for front and rear drum brakes with excellent durability and braking performance. Ideal as an OEM replacement. Dimensions: 110x25mm
Reference: SCT-BD012/BK
Brand: Scootertuning.ca
We offer here TWPO 220mm brake disc, the perfect brake disc in conjuction with TRS front hub and NCY, RRGS or lowdown Ruckus fork.
Reference: S6-5016628
Brand: Stage6
Stage6 have extended their clutch range to include the Sport PRO version. This three-shoe clutch can be adjusted by using different clutch springs and choosing between two lock-in positions. Its beefed-up clutch shoes are held in place with a reinforcing ring and forged screw-in bolts that are superior to the riveted studs commonly used in conventional...
Reference: MF15.16600
Brand: Motoforce
Replacement intake for Yamaha zuma 2002-2011 / Minarelli horizontal replicas
Reference: S6-4036/BK
Brand: Stage6
The Stage6 MKII Mini Fuel Gauge received a visual overhaul. A fuel gauge is a pretty important, if not indispensable, little device for every bike owner. The popular Stage6 mini instrument is suitable for every vehicle type and model. A clean and easy to read display shows how much fuel you have left in your tank. The gauge can be adjusted to...
Reference: 203.0097
Brand: Polini
We can now offer you these air filters from Polini. A splash protection that can be installed additionally, they are primarily intended for sporty use. Please remember: when using this carburettor, you will need to upjet your carb (depending on your tuning stage) or otherwise risk engine damage.
Reference: A187002
Brand: NGK
Racing spark plug cap with resistor and HT lead by NGK
Reference: 12-UP4182ST
Brand: Uni
High Quality Dual Layer air filter made by UNI. Uni Universal Air Filters is where it all started over 40 years ago. Make a trick filter that clamps directly to the carburetor. For use on motorcycles, go-karts, tractors, air compressors, snowmobiles, anything with a carburetor can benefit from a Uni.
Reference: 314-4184
Brand: Uni
High Quality Dual Layer air filter made by UNI. Uni Universal Air Filters is where it all started over 40 years ago. Make a trick filter that clamps directly to the carburetor. For use on motorcycles, go-karts, tractors, air compressors, snowmobiles, anything with a carburetor can benefit from a Uni.
Reference: 353-0579
Brand: Maxima
A high performance synthetic blend for both injector and premix use. Special synthetic lubricants and advanced additives provide for outstanding engine performance and protection while maintaining excellent engine cleanliness and eliminating exhaust smoke. Exceeds API-TC and all manufacturer’s specifications.
Reference: 5DA-E5451-10-00
Brand: Yamaha
Crankcase cover gasket with exact fit. Made to replace the factory installed gasket.
Reference: 298360.W0
Brand: Malossi
We can offer various torque springs from Malossi. The main thing about adjusting an engine is to find the right combination of torque spring, variator weights and clutch springs. If the drive belt slips, you will have to go for a stiffer torque spring. On the other hand, choosing a spring that is too stiff will also reduce power output. If you have any...
Reference: SCT-GA004
Brand: Scootertuning.ca
Replacement gasket that will be fitted below the alternator stator. Some trimming could be required in some cases.
Reference: S6-8016601
Brand: Stage6
The Stage6 HPC (high primary compression) crankshaft is a full-circle crankshaft, and as such increases primary compression in the crankcase. It has been developed in cooperation with F. Koopmans and is completely made of metal (i.e. no plastic padding). The bearings can handle up to 16,000 rpm! Made in Italy.
Reference: 4DY-E262H-00-00
Brand: Yamaha
Remplacement Fan cooling cover spoiler for Yamaha Bws / Zuma 2002-2011
Reference: SCT-AER02
Brand: Ruckhouse
Everything you need to eliminate your stock Honda / Metropolitan air box with the most popular parts. When you remove your stock air box you will need to re-jet the carburetor. We recommend you add a performance exhaust at the same time so you are only tuning your carburetor once. Kit includes: Cone Mesh Emgo Air Filter, Intake tube with pvc fitting to...
Reference: P40FORK455012
Brand: Athena
Athena offers the most complete range of fork oil seal kits and dust seal kits; furthermore, on special applications we can offer a single fork kit, composed of, one oil seal and one dust seal. The quality of Athena oil seals meets or exceeds OEM quality. Made in Italy.
Reference: 4615434
Brand: Malossi
Oil-gas shock absorber with adjustable spring preload, 35 mm longer wheelbase in comparison with original shock absorber. This range of shock absorbers was born thanks to Malossi to offer their customers a range of products of superior class, capable of granting great riding comfort coupled with matchless driving safety. The technical characteristics of...
Reference: 343.0023
Brand: Polini
Polini offer here adaptor for use 37mm connection Airfilter with theirs CP Carburretors. Most of airfilters are only available with 33-36mm connection, this parts allow you to use it on the CP carb. Note! The CP carburretor 17.5 to 21mm have 47mm airfilter connection diameter.
Reference: NK100.30
Brand: Naraku
The NARAKU 50cc cast iron cylinder kit is an affordable and robust alternative for those who require a replacement due to cylinder or piston damage. The power output is somewhat higher than on the original barrel. Very good value for money, simple replacement cylinder kit. Supplied with gasket set; the original head is retained. Parts for this kit can be...
Reference: 473398
Brand: Tun'R
Tun'r offer here glue-on indicators ''Raindrop'. Stylish drop-shaped signal lights that can be glued to every smooth surface.
Reference: 16783
Brand: Scootertuning.ca
Starter motor for upright and horizontal 50cc Minarelli scooters.
Reference: L-SASTAGE6/WH
Brand: Stage6
This is the most famous Stage6, the one you definitely can’t do without! Available in black or white writing.
Reference: 27-L544
Brand: Motul
100% Synthetic 2-Stroke motorcycle racing lubricant developed for Factory Teams. 800 Factory Line lubricant takes advantage of the ESTER Core® Technology to ensure you maximum power output of the engine without compromising the reliability and the wear. By selecting esters over other high performance synthetic base stocks and combining them with an...
Reference: BR8ES-5422
Brand: NGK
The thermal grade of the spark-plug is of prime importance with tuning kits; if the wrong grade is used the kit will overheat or the spark-plug will foul. A hotter spark plug transfers more heat to the cyl head, which may lead to piston seizures. The Corsa kit comes with the correct spark-plug, for other kits we recommend the plug listed here. As a rule...
Reference: ABZ060R
Brand: Yasuni
Yasuni Silencer Bracket with CNC-cut logo.