Scooter / Motorbike

Accessories

Custom Wheels

Top sellers

New products

Specials

Viewed products

Reduced price!

-10%

GY6 150cc Engine Motor 1P57QMJ (Long Case) View larger

GY6 150cc Engine BN157QMJ Long Case (54mm spacing)

SCT-GY6150

New product

Scootertuning.ca

150cc 4-Stroke Long-Case GY6 Gas Engine with automatic CVT transmission. This scooter engine is used in a wide variety of applications, including full-size street legal scooters, all terrain vehicles (ATVs), dirt bikes, and go karts. Compatible with both 125cc and 150cc engine size scooters and vehicles.

More details

In stock

CAD$ 611.99

CAD$ 679.99

More info

150cc 4-Stroke Long-Case GY6 Gas Engine with automatic CVT transmission.

This scooter engine is used in a wide variety of applications, including full-size street legal scooters, all terrain vehicles (ATVs), dirt bikes, and go karts. Compatible with both 125cc and 150cc engine size scooters and vehicles.

This complete engine includes electric starter, kick start, and CVT.

Engine is EGR.

 

Please Read The Following Important Notices:

This complete engine includes electric starter, kick start, and BLACK CVT.

Disconnect this hose once installed and run Transmission overflow to back and hose on the Cylinder towards front and down. See pics below

Engine is set up for PAIR Emissions System. PAIR is an acronym for Pulsed Secondary Air Injection System.

It is an emissions control system used to lower HC and CO emissions. It works by allowing air into the exhaust flow

Please Read The Following Important Notices:

This engine is shipped WET, included is 10/40 Oil  and Transmission Fuild ALREADY INSTALLED

.9 LITERS OF ENGINE OIL NO MORE NO LESS. IF ON RUCKUS DIPSTICK WILL NOT SHOW OIL ABOUT 1/2 OF TRANNY FLUID ON TRANNY SIDE.

Check oil level before the first start and after letting the engine idle for a few minutes, add additional oil if needed.

GY6 125cc and 150cc engines come in different sizes. Please measure the physical size of your engine and compare to our specifications before ordering if not for Ruckus Swap. The difference is in the length of the rear swing arm. Different lengths have been made to accommodate different wheel sizes.

For rear drum brakes only.

No-return policy on all engines.

Accessories

  • Reference: S6-35013BL

    Brand: Stage6

    Air filter Stage6 short Blue (44mm)

    More and more air filters come with bigger fitting diameters to optimize the carb’s air flow. We offer you air filters of this design for Mikuni (44mm fitting diameter) and for Stage6 flat-slide/ Keihin (48mm fitting diameter) carburetors. They are available in red and blue and of course can also be used for other carbs with similar fitting diameters....

    CAD$ 48.44 CAD$ 56.99 -15%
    Add to cart More
    Out of stock
  • Reference: MF16.30020

    Brand: Motoforce

    Fuel pump Motoforce DF-44

    This mechanical fuel pump from Olympia is identical to the one from Mikuni, but available for a better price.The output is about 14l/h, which is absolutely sufficient for most 2-stroke engines. Recommendable for all highly tuned engines with big bore carbs (24mm and more).

    CAD$ 28.89 CAD$ 33.99 -15%
    Add to cart More
    In stock
  • Reference: MF12.00040

    Brand: Motoforce

    Ignition coil Motoforce RACING 2-pins (Removable Tip)

    This ignition coil from Motoforce Racing nearly doubles the secondary voltage. The standard ignition voltage of the original ignition coil is around 16,000 V, and with this coil, you can reach a voltage of an amazing 31,000 V! The advantage is that it transforms the primary voltage more effectively. A high ignition voltage ensures a clean ignition at very...

    CAD$ 33.99 CAD$ 39.99 -15%
    Add to cart More
    In stock
  • Reference: TRS-TCS6CVK

    Brand: TRS

    Throttle Cable TRS (Stage6 Throttle to CVK Carb)

    TRS Stage 6 to CVK throttle cable will allow Stage 6 (SSP) controls to be installed with CVK carburetors. Ideal for those who are upgrading from stock handle controls to Stage 6 or KOSO units. TRS Throttle SSP to CVK throttle cable will also work with other motorcycles or scooters that has the same type of fitting for the carburetor (all Stage 6 or KOSO...

    CAD$ 23.79 CAD$ 27.99 -15%
    Add to cart More
    In stock
  • Reference: TRS-MFPB/

    Brand: TRS

    Fuel Pump & Coil Bracket TRS Honda Ruckus

    Looking for a stylish way to mount your Mikuni DF-44 Rectangular fuel pump? This is IT. Available in Raw or Anodized

    CAD$ 52.69 CAD$ 61.99 -15%
    Add to cart More
    Product available with different options
  • Reference: SCT-H053-001

    Brand: Scootertuning.ca

    Ignition Coil GY6 / Honda 2 pins

    We offer here inexpesive replacement coil for Honda and GY6 engine.

    CAD$ 16.14 CAD$ 18.99 -15%
    Add to cart More
    Out of stock
  • Reference: TRS-HRGWH/PSP

    Brand: TRS

    Engine Swap Harness PSP Honda Ruckus GY6

    PSP plug and play GY6 engine harness will eliminate the need to fuzz around with wiring your engine swaps! Reduce the chances of errors and problems. Pre-labeled and ready to go!

    CAD$ 280.49 CAD$ 329.99 -15%
    Add to cart More
    Out of stock
  • Reference: 1000-1287.10

    Brand: NCY

    NCY Brake Shoes (Blue) GY6 125-150cc

    NCY High Performance Grooved Brake Shoes - GY6 High friction grooved linings, efficiency improves with heat. NCY Blue Series brake shoes are made using high pressure Die cast aluminum platforms with bonded brake linings. All shoes are radius ground and edge trimmed and also feature lead in and lead out chamfers at lining ends and original equipment style...

    CAD$ 28.04 CAD$ 32.99 -15%
    Add to cart More
    In stock
  • Reference: S802-343/AL

    Brand: Ruckhouse

    Rear Hub Multi Bolt partern Aluminium 4x102, 4x110, 4x130 GY6 125-150cc

    Looking to run a fatty rim on a Honda ruckus with GY6 motor? here's the hub you need. The hub has 4x102, 4x110 & 4x130 bolt pattern that allow to use lot's of Douglas & Aftermaket 12x8 / 12x7 wheels.  4x102 Bolt pattern is already including studs. We recommend our lug nuts to install the wheel. 4x110 and 4x130 Can be used with Regular M10 bolts or...

    CAD$ 135.99 CAD$ 159.99 -15%
    Add to cart More
    In stock
  • Reference: TRS-EMFWG/GY6

    Brand: TRS

    Engine Mount TRS 8 Wide Wheel for Honda Ruckus with GY6 125-150cc engine"

    TRS offer here Ruckus GY6 125-150 conversion mount. Allows you to run the 12x 7, 12x8 or 10x8 Fatty rim. Comes with an angled clocking flange. Carb must face forward. TRS mount is a SOLID piece of Billet Aluminium so it's super strong. We also include an angled clocking instead of having to purchase one. Brackets are stainless steel.

    CAD$ 371.44 CAD$ 436.99 -15%
    Add to cart More
    Out of stock
  • Reference: SCT-164-30

    Brand: Scootertuning.ca

    Rear Axle Nut M16 for GY6 125-150cc

    Rear axle nut for GY6 125-150cc Short/Long wheel axle.

    CAD$ 3.39 CAD$ 3.99 -15%
    Add to cart More
    Out of stock
  • Reference: GY16640

    Brand: Scootertuning.ca

    Rear output shaft – Short version for GY6 125/150cc

    Gearbox output shaft (wheel shaft) for GY6 125/150cc 4-stroke Chinese-built engines. This version is for vehicles with a rear drum brake. Shaft length 135mm.

    CAD$ 23.79 CAD$ 27.99 -15%
    Add to cart More
    In stock
  • Reference: 1000-1131.1

    Brand: NCY

    Rear Axle Nut NCY Electroplated M16 for GY6 125-150cc

    High quality electroplated rear axle nut by NCY for GY6 engines.

    CAD$ 10.19 CAD$ 11.99 -15%
    Add to cart More
    In stock
  • Reference: SCT-164-103

    Brand: Ruckhouse

    11 Coil Stator 3 Phase – AC CDI (157QMJ) GY6 125-150cc

    11 Poles Stator for GY6 150cc engine that supply more power as the 8 poles stator include with the engine.

    CAD$ 41.64 CAD$ 48.99 -15%
    Add to cart More
    Out of stock
  • Reference: SCT-114-52

    Brand: Ruckhouse

    Manual Choke Conversion Kit (CVK 18-30mm)

    CAD$ 25.49 CAD$ 29.99 -15%
    Add to cart More
    Out of stock
  • Reference: GY16651

    Brand: Scootertuning.ca

    Carburetor CVK 24mm for GY6 125-180cc

    Complete replacement 24mm carburettor (membrane type) supplied with electric auto choke. Ready to fit and suitable for 125/150cc Chinese-built engines and 125cc air-cooled Kymco models. This is a Chinese-built carb and matches the quality of the original item. Uses M5 main jets.

    CAD$ 78.19 CAD$ 91.99 -15%
    Add to cart More
    In stock
  • Reference: DG128354110

    Brand: Douglas

    Rear Fatty Wheel DWT 12x8 3+5 (4x110)

    Douglas 12X8 3+5 Offset Polished Rims with 4/110 bolt pattern. Must use an GY6 4/110 hub or similar. This wheel is for Ruckus with GY6 engine with Fatty Engine Mount. Please choose if you want hub cap include or not.

    CAD$ 191.24 CAD$ 224.99 -15%
    Add to cart More
    Out of stock
  • Reference: YS-701GY6/CA

    Brand: Yoshimura

    Exhaust Yoshimura RS-2 Carbon V2 Short Fatty GY6 125-180cc

    Custom GY6 Genuine Yoshimura Exhaust with Stainless header. With custom STAINLESS STEEL bracket for Fatty 10 inch 12x7, 12x8 or 13" tire. Comes with all mounting hardware and exhaust plug.

    CAD$ 637.49 CAD$ 749.99 -15%
    Add to cart More
    Out of stock
  • Reference: GY16359

    Brand: Scootertuning.ca

    Transmission / Gear Box cover gasket for GY6 125-150cc

    Gasket for the gearbox cover on GY6 125/150cc 4-stroke engines.

    CAD$ 5.09 CAD$ 5.99 -15%
    Add to cart More
    In stock
  • Reference: GY33295

    Brand: Scootertuning.ca

    Brake Shoes 125x27mm GY6 125-150cc

    Replacement rear brake shoe set inc 2 springs corresponding to original part. Dimensions: 125mm x 27mm

    CAD$ 12.74 CAD$ 14.99 -15%
    Add to cart More
    In stock

Customers who bought this product also bought:

5 other products in the same category: