No products
High-quality replacement gudgeon pin circlips from Malossi for 10mm and...
The HAT weights are very durable and self lubricating. Available in a...
Pro Taper is well known for manufacturing high-quality grips and...
Budget weights by Motoforce, choice of weights. Available in a range of...
Replacement reed valve gasket for all Minarelli Horizontal engines.
The thermal grade of the spark-plug is of prime importance with tuning...
In order to offer optimal handling, a dragrace handlebar should be...
The thermal grade of the spark-plug is of prime importance with tuning...
The transmission bearings of a Minarelli crankcase are mounted in the...
This piston ring set for 88cc GY6 cylinders (52mm bore) is specially...
Replacement Malossi Piston for 88cc Malossi cylinder GY6 50cc
Complete cylinder gasket set for 52mm Malossi 4-stroke cylinder sets Kit...
Replacement silencer for Exhaust Stage6 R/T FL 100cc RC-ONE / P.R.E
It is a classic racing exhaust made of carefully hand-welded thin steel...
Ready to bring your bike into a class...
Viewed products
The NCY cdi is the part needed to give you the...
The NCY cdi is the part needed to give you the extra power needed for your Honda Ruckus. The NCY cdi will removed the rev limiter from the OEM cdi. See Lower the information you need for the proper installation.
In stock
-the yellow and orange wire need to be connect to the coil (coil to the orange and yellow to the OEM wire)
-the blue wire connect to the ''service'' plug
-the red wire (alone) is useless
-the red and green plug need to be connect to the other connector supply with the CDI. The green to the battery negative (-) and the red to the red/green wire. This wire is connect to the starter relay near the battery. You can use the blue crimp plastic part, or weld it.